Back to Blog
Dishwasher6 min read

Why Is My Dishwasher Not Draining? Troubleshooting Guide

By EasyBear Team2026-02-11

Finding standing water at the bottom of your dishwasher after a cycle is one of the most frustrating appliance problems. Not only does it prevent your dishes from getting clean, but it can also lead to unpleasant odors and potential water damage if left unaddressed.

The good news? Most drainage problems have simple causes that you can check yourself before calling a professional. In this guide, we'll walk through the 5 most common reasons why dishwashers don't drain and what you can do about each one.

1. Clogged Dishwasher Filter

The Problem: This is the #1 cause of drainage issues. Your dishwasher's filter catches food particles, and over time it can become completely blocked.

Location: Usually found at the bottom of the dishwasher tub, either in the center or back corner. It's typically a cylindrical or flat mesh component.

How to Check:

  • Remove the bottom dish rack
  • Locate and twist/pull out the filter (consult your manual if unsure)
  • Look for visible food debris, grease buildup, or blockages

DIY Fix:

  1. Remove the filter
  2. Rinse under hot running water
  3. Use a soft brush to scrub away stuck-on debris
  4. Check the filter housing for debris
  5. Reinstall the filter properly

Difficulty: Easy - takes 5-10 minutes

Prevention: Clean your filter every 2-4 weeks, especially if you don't pre-rinse dishes.

2. Blocked Drain Hose

The Problem: The drain hose connects your dishwasher to your home's plumbing. If it's kinked, clogged, or installed incorrectly, water won't drain.

How to Check:

  • Pull the dishwasher slightly away from the wall (may need to remove toe kick)
  • Inspect the drain hose for kinks or bends
  • Feel along the hose for hard spots that might indicate clogs

DIY Fix:

  • If kinked: Straighten the hose carefully
  • If clogged: Disconnect hose (have a bucket ready!) and flush with hot water
  • Check that the hose isn't installed too low (should loop up higher than drain connection)

Difficulty: Moderate - requires some physical access to back of dishwasher

When to Call a Pro: If you can't access the hose or aren't comfortable disconnecting plumbing.

3. Faulty Drain Pump

The Problem: The drain pump actively pushes water out of your dishwasher. If it fails, water just sits there. You might hear unusual grinding or humming sounds.

Symptoms:

  • No sound during drain cycle (pump not running)
  • Grinding or buzzing noise (pump running but obstructed)
  • Water drains very slowly

How to Check:

  • Listen during the drain cycle for motor sounds
  • Check for debris blocking the pump impeller (visible after removing filter)

DIY Fix: You can remove visible debris blocking the impeller, but pump replacement requires professional expertise.

Cost to Repair: $150-$250 for professional pump replacement

Difficulty: Difficult - not recommended for DIY unless you have appliance repair experience

4. Garbage Disposal Connection Issues

The Problem: If your dishwasher drains into a garbage disposal, two common issues can cause problems:

  • The disposal's drain plug hasn't been removed (in new installations)
  • The disposal inlet is clogged with food debris

How to Check:

  • Run your garbage disposal with water - does it drain quickly?
  • If recently installed, check if knockout plug was removed from disposal
  • Look inside disposal drain inlet for obvious blockages

DIY Fix:

  • Run disposal with hot water to clear debris
  • If new installation, knockout plug must be removed (requires tools and disposal access)
  • Use a disposal cleaning solution monthly

Difficulty: Easy to moderate depending on issue

5. Air Gap Blockage

The Problem: If you have an air gap (small cylindrical fixture next to your faucet), it prevents sewer gases from entering your dishwasher. But it can also get clogged.

Symptoms:

  • Water overflowing from air gap during drain cycle
  • Gurgling sounds

How to Check:

  • Remove the air gap cap (usually just lifts off)
  • Look inside for debris or buildup

DIY Fix:

  • Remove debris from air gap
  • Flush with hot water
  • Use a small bottle brush to clean inside

Difficulty: Very easy - takes 5 minutes

When to Call a Professional

While many drainage issues are DIY-fixable, call EasyBear or another professional if:

  • You've checked all the above and water still won't drain
  • You hear unusual electrical buzzing or burning smells
  • Water is leaking from underneath the dishwasher
  • The drain pump needs replacement
  • You're not comfortable working with plumbing connections
  • The dishwasher is still under warranty

Repair Costs

Average costs in the Bay Area:

  • Service call + diagnosis: $75-$100
  • Filter cleaning (if you call us out): Usually free with service call
  • Drain pump replacement: $150-$250
  • Drain hose replacement: $100-$150
  • Control board issues: $200-$350

Remember: Regular maintenance (cleaning the filter every few weeks) can prevent 80% of drainage problems!

Prevention Tips

Keep your dishwasher draining properly with these simple habits:

  1. Scrape dishes (but don't pre-rinse completely - your dishwasher needs some soil to activate detergent)
  2. Clean filter monthly - set a calendar reminder
  3. Run hot water at sink before starting dishwasher to ensure hot water enters
  4. Use quality detergent - cheap detergent can leave residue
  5. Run disposal before dishwasher if they share a drain
  6. Monthly cleaning cycle with dishwasher cleaner or white vinegar

Frequently Asked Questions

Q: Why is there standing water at bottom of dishwasher after cycle? A: The most common cause is a clogged filter (80% of cases). Remove and clean the filter first. If that doesn't work, check the drain hose for kinks or clogs.

Q: Can I run my dishwasher if it's not draining? A: No, you should not run it again. The standing water will overflow when you add more water in the next cycle. Fix the drainage problem first.

Q: How much does it cost to fix a dishwasher that won't drain? A: Simple fixes like cleaning the filter are free. Professional repairs range from $100-$250 depending on the issue. Drain pump replacement typically costs $150-$250 in the Bay Area.

Q: Is standing water in dishwasher a health hazard? A: After 24-48 hours, yes. Stagnant water becomes a breeding ground for bacteria. Either fix it quickly or remove the water manually and keep the door open until repaired.

Q: Should I use Drano or drain cleaner in my dishwasher? A: Absolutely not! Chemical drain cleaners can damage your dishwasher's rubber components and plastic parts. Stick to hot water and mechanical cleaning.

Need Professional Help?

If you've tried these troubleshooting steps and your dishwasher still won't drain, EasyBear can help:

  • Same-day service available in the San Francisco Bay Area
  • Free diagnosis with repair (just a service call fee if you decline repair)
  • 90-day warranty on all repairs
  • All major brands serviced

Don't let standing water in your dishwasher disrupt your routine. Book a repair appointment online or call us today!

Arcane

Need Professional Help?

Can't fix it yourself? Our certified technicians are ready to help.

Book Repair Service

Same-day service • 90-day warranty • Free diagnosis

Why Is My Dishwasher Not Draining? Troubleshooting Guide | Arcane Blog